Safety

The Project Builder and Catalogue produce indicative product recommendations based on the information provided. They are planning tools, not a substitute for professional engineering assessment.

Diverse Works Holdings does not automatically certify electrical safety, circuit design or installation compliance through these tools. Any warnings shown (for example around connected load or outdoor IP ratings) are general planning flags, not a safety sign-off.

Before supply, schedules involving distribution boards, protective devices, changeover equipment or industrial installations are reviewed by qualified DWH technical staff. Where a requirement falls outside standard parameters, additional engineering input may be required before we can confirm the order.

Electrical installation work must be carried out by a competent, registered electrical contractor. DWH supplies products and technical guidance; we do not perform or certify installation work unless expressly contracted to do so.

Power distribution is planned against the estimated connected load of the specified products. Clients are responsible for confirming supply capacity and circuit design with their appointed electrical contractor; where supply may be insufficient, this is flagged during configuration and confirmed during technical review.

Outdoor and damp installations require appropriate IP-rated enclosures, sockets, isolators and accessories. Weatherproofing is recommended by default for outdoor configurations; final suitability must be confirmed by the installing contractor.

Products are sourced to applicable South African and international standards. Certificates and datasheets are available on request for specified items.

Any safety concern relating to a supplied product should be reported to DWH immediately. Clients are encouraged to isolate the product where safe to do so and to raise the issue with a DWH technical specialist via the Contact page.